In the process of engraving, engraving machine has various defects of dislocation, such as left-right dislocation, up-down dislocation, X-axis dislocation, z-axis dislocation, etc. What causes the appearance of dislocation of engraving machine after all?
1. Check whether the way of carving software is correct or not;
2. Check the space size of the screw rod and whether the fastening screw of the polished rod is loose;
3. Check whether the software parameters are set correctly.
4. Check whether the ground wire is well connected
5. Is the computer virus or incompatible with other computers or annoying? Generally speaking, it is not necessary to simply assemble the chassis of the brand machine
6. Check whether the coupling on the front and upper part of the water-cooled spindle motor is loose or damaged. Tighten it by hand or replace it
7. Is there any poor contact between the wire on the engraving machine crossbeam and the chain connecting the machine control box
8. driver 's question: the layout of the driver itself may be in doubt with the electronic original equipment, which will also form the dislocation appearance. This reason is the most; if the frequency of occurrence is not large, and the speed is reduced a bit, sometimes the driver can be carved normally, which indicates that the driver has not been completely broken; if the driver is carved at the beginning of dislocation, it indicates that the driver is completely broken. How to do it: repair the drive or replace it.
9. Question of voltage: the engraving machine needs high power during operation. If the voltage is too low, the power supply to the driver is insufficient, and the power is not up to, it will form a dislocation image. In general, the y-axis dislocation is the most common situation. The appearance may be that the external voltage is impossible. Maybe someone uses high-power equipment such as electric welding on the same line. Treatment: install a 5000 Watt regulated power supply, but the fault planning of the regulated power supply s
Company news
